Charge 2 batteries through one charger or an alternator
Great for keeping an electronics battery charged while on the water
Waterproof IP68 Rated
The Combiner 100 is a voltage-sensing relay which connects two batteries together when either is receiving a charge. When the charging ceases, the relay opens so that each battery operates independently. Supplemental battery banks can be added by using an additional combiner for each bank. You never have to worry about switching to "BOTH" when your engine is running and forgetting to switch back to save your starting battery from discharge when you stop.
This combiner is suitable for installations with alternators up to 100 amps with one battery in each bank. Larger installations should consider using the 200 Amp model.
Yandina Combiner - Lithium
75 amps continuous rating, 400 amps closing current (2 seconds), 100 amps for 5 minutes
Suitable for alternators up to 100 amps, up to 18 volts. Larger charging sources should use the Combiner 200.
Waterproof rated IP68 Protected from long term immersion
LITHIUM compatible version available
No voltage drop so batteries reach full charge
Electronic thermal monitoring with shutdown and automatic restart.
Minimal wasted power, no heat sink or cooling required
Can be used on alternators with internal or external regulators
Alternators with external voltage sense require no special wiring
Simple basic installation, two battery wires and ground
Complete with all cables and terminals for basic hookup
Green LED indicates when combined
Red LED indicates temporary thermal overload shutdown
Draws no current when batteries are not being charged
Draws less than 150 milliamps when charging is in progress